Position_endstop in section 'stepper_z' must be between position_min and position_max

General Discussion
1

Basic Information:

Printer Model: Biqu bx
MCU / Printerboard: SKR SE-BX
Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…hello after a probe calibrate z
klipper to restart and i have this error i can’t restart klipper properly
Can you help me? Thank you very much

I’m French sorry if my English isn’t great

2

klippy.zip (1.1 MB)

3

Your [probe] has a negative z-offset, which is impossible as this would mean your probe is below your bed (might be possible but I would not recommend trying).

4

I don’t know how to change the offset
because the printer doesn’t restart and I don’t know what to modify in config

5
  1. Set the z-offset to 0 in [probe]
  2. Follow Bed leveling - Klipper documentation