Basic Information: Printer Model: FLSUN V400 MCU / Printerboard: Robin Nano 2.0 klippy.log (1.7 MB) Describe your issue: So I’m starting to level using the probe z-offset. It’s doing the probe clicking, then lifts, I remove the probe and then I go down to 0.1mm using a feeler gauge. Save + r…

[image] cottec: klippy.log not sure how to log the correct thing… But it can help to find a flaw. Please attach it to your next post. [image] cottec: How could I log and share the procedure? Multiple klippy.logs? Usually the log includes several runs. And if it is too long, you can …

ah different location… klippy.log (1.7 MB) after the bed mesh it’s sitting 0.7 too low… Meaning the z offset is 0 now, I move the printer to 1.000 but the distance between nozzle and bed is just about 0.3mm should I just add 0.7 to the probe offset?

There are some macros that set the offset to 0. For whatever reason. Usually you do not need any additional tools/macros to calibrate the z_offset. https://www.klipper3d.org/Probe_Calibrate.html#calibrating-probe-z-offset Important: You have to do a Z_OFFSET_APPLY_PROBE before a SAVE_CONFIG http…

will try… could you highlight the “faulty” macros, I could ask the dev to correct it…

Just noticed: You have a delta printer. Things look different here: [image] Use probe to set z offset? General Discussion I have a delta (FLSUN QQ), so there are end stop switches at the top. Let me first say I don’t entirely understand which config values determine whe…

what is the outcome? probe z calibration, delta calibration, probe z calibration? tbh I didnt touch the delta calibration, it was fine since the last time

About the mentioned thread by me you should know that eventually I found that delta or bed mesh calibration using the probe was waaaay too inaccurate, so I did that manually and I only use the probe to manually measure the thickness of any material I put on the bed. I’d still like to know how to aut…

hm okay, not very satisfying :smiley: but how can it be that other users in a huge facebook group are not complaining? one more thing that might be interesting…wtf? [image] probably the explanation for any misbehaviour is here… https://www.klipper3d.org/Probe_Calibrate.html#location-bias-check …

alright, looks like the probing is garbage… this is my manual bed after manual delta calibration [image] if I ignore the corners(which should be just interpolated anyways I guess) that means I’ve got two high edges of the circle and two low edges. Kind of makes sense if the plate underneath is f…

well, that’s something you’d have to do anyways, no? [image] AndreKR: I’d still like to know how to automate that Does somebody know of the DELTA_CALIBRATE is using the old calibration values or does it clear the values before? If it’s keeping the old values it would just make sense to jus…

Z Offset is off by 1mm

General Discussion

EddyMI3D November 29, 2023, 7:41pm 6

Just noticed: You have a delta printer.

Things look different here:

Topic		Replies	Views
Bad print quality and z-offset not saving General Discussion	20	859	December 17, 2024
Use probe to set z offset? General Discussion	12	2327	November 30, 2023
Probe_Calibrate does not function correctly or within a normal range? General Discussion	8	3377	April 28, 2024
Printer prints in the air General Discussion	5	318	February 9, 2024
Z in mid air at start..Fails to lower General Discussion	8	173	March 14, 2025

Z Offset is off by 1mm

Related topics