Accelerometers does nothing when command is sent

[Nicrc211]

Basic Information:

Printer Model:
MCU / Printerboard:
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…It shows the ACC values. The head does nothing when the command is sent. It shows accelerometer measurements started. Nothing happens.

[Sineos]

If your goal is to measure the values for the resonance compensation, then you are using the wrong command. Refer to the documentation for the proper commands.