After update Klipper is disconnected

[mykepredko]

@Onkel666

I’ve been following this but not sure if I can add anything because I simply don’t know anything about your setup.

I’m very surprised nobody has asked you to provide the information that was requested when you put in the following post (namely printer type, main controller board, SBC & klippy.log):

How-To Ask for Help

How-To Ask for Help General All contributors here help out in their spare time and because they want to give something back to the Klipper project. Be respectful and patient. If someone knows the answer to your question, they will answer it. Choose the right Category Questions / Issues should go into the General Discussion category most of the time. Filling the template is mandatory. The categories Config, Developers and Macros are used to post results of one’s work for the benefit of others T…

I think you’ll find that by providing the information initially required for a “General Discussion” request, you’ll make the process much more efficient.