Basic Information:
Printer Model: Anycubic i3 Mega
MCU / Printerboard: Trigorilla
Host / SBC Ubuntu PC
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
Hello
I uploaded the klipper firmware to the printer from an Ubuntu PC, then tried to set up the klipper, but it does not connect to the usb.
klippy.log (229.8 KB)
…