Basic Information: Printer Model: Voron 2.4 R2 MCU / Printerboard: Octopus 1.1 Host / SBC: Raspberry PI klippy.log: Yes Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “…

Except the macros for the webinterfaces and not even these are strictly needed. It is absolutely beyond me, why users have some dozens of macros in a standard printer and not even a working base config. You have two options: Kick out all these macros unless you know what they are doing and you kn…

I copied the entire file. Not sure what could have been left out. However the Bed Mesh Calibrate will work without the included bed_mesh.cfg?

As stated above: You do not need any macros for a standard printer unless specifically called out by some piece of hardware by the relevant manufacturer. In addition, many of them are: Not properly documented Outdated Not maintained Unneeded All above Maybe someone is willing to dig into such ma…

Can you point me to the correct way to do the bed meshing? Without including the bed_mesh.cfg?

I’ve commented out the include bed_mesh.cfg. Now it fails every time with a message that home should be performed evan after homing.

I issued a G28 and then the bed mesh calibrate. This worked. Clicking the macro homed but didn’t seem to be recognized by the bed mesh calibrate.

BED_MESH_CALIBRATE PROFILE="default" fails

General Discussion

Sineos July 21, 2024, 4:03pm 6

For a new printer setup you might want to follow this

Topic		Replies	Views
Error evaluating 'gcode_macro BED_MESH_CALIBRATE:gcode': UndefinedError: 'dict object' has no attribute 'polygon' General Discussion	9	1935	July 7, 2023
Unknown command:"BED_MESH_CALIBRATE[" General Discussion	4	714	October 11, 2024
Unknown commands and double bed meshing General Discussion	5	2101	February 12, 2023
ENSURE_BED_MESH for Print Start gcode Macros	9	181	May 12, 2026
Bed Mesh Error General Discussion	2	101	January 29, 2026

BED_MESH_CALIBRATE PROFILE="default" fails

Related topics