Bed screws config

General Discussion
1

Basic Information:

Printer Model: vzbot 330
MCU / Printerboard: mantam8-
Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

this not so much an issue more just question can klipper calculate rotational distance for 6-32 bed screws ? if so is it as simple as just changing the cfg file from m3 cw to 6-32 cw ?

thanks

2

grafik
grafik1245×254 22.6 KB

See Configuration reference - Klipper documentation

3

thanks i see i didnt scroll down far enough when looking at the documentation i was looking in the bed screws portion not the screws tilt adjust portion

4

This topic was automatically closed 30 days after the last reply. New replies are no longer allowed.