Basic Information: Printer Model: Core XY MCU / Printerboard: Manta 8P + EBB42 Host / SBC CB1 klippy.log Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “Knowledge Base”…

Rather than a three year old video, I suggest that you follow the Esoterical guide: Home A guide for setting up CANBus hardware on 3D printers It’s been kept up to date regarding the updates to the various host operating systems and Klipper.

I followed this but can get the board into CAN mode… Is this correct config? [image]

That’s what I use for my printer that uses a Manta M8P V2.0. What steps did you go through to get to the point of loading Katapult/Klipper? You should be starting with a freshly imaged SD Card and not one that you’ve been working with.

I am following steps from this https://canbus.esoterical.online/

Are you using a USB cable to flash katapult to the EBB42 ? Been a while since I changed my Idex to canbus but if I recall there is a button combination on the EBB boards to put them into flash mode. To flash my Octopus board I had to install the DFU jumper then remove it when done, not sure about …

Sorry for delay in reply. I referred the website https://canbus.esoterical.online/ and successfully installed OS image and other stuff on Manta 8P V2 + CB1 + EBB42 V1.2. Thanks all for the help you provided.

Cannot get UUID

General Discussion

EddyMI3D July 3, 2025, 1:02pm 2

You had a look here? CAN Basics

Topic		Replies	Views
CAN Bus config / EEB36 General Discussion	5	219	August 6, 2025
Problem setting up CAN-Bus - no UUID after flashing klipper General Discussion	1	1691	January 14, 2024
Lost CAN uuid after reboot Manta M8P V2 General Discussion	39	4871	January 22, 2024
Manta M8P+CB1+U2C+EBB36 General Discussion	13	2034	January 26, 2023
BTT EBB42 not flashing over CanBoot General Discussion	1	853	December 21, 2023

Cannot get UUID

Related topics