Cant home X,Y or Z axis

General Discussion
1

Basic Information:

Printer Model: ender3v2
MCU / Printerboard: Manta 3ez v1
Host / SBC: cb1
klippy.log
klippy (18).log (2.0 MB)

Describe your issue:

When trying to home an axis the stepper motors just vibrate and lock up until i enter M84. Ive tried straight wiring and crossing the middle two wires. only differnce i notice is its a little louder with the wires crossed.

2

This is not a CoreXY printer.

[printer]
kinematics: corexy # ------> replace with kinematics: cartesian
3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.