Basic Information: Printer Model: Ratrig MCU / Printerboard: octopus v1.1 …when i send it home the clipper shuts down, where is the error? thank you for the help I’ve made too many changes to the printer.cfg file and now I can’t get out of it. I hope there is someone who can help me klippy (3)…

[image] h5a6: when i send it home What do exactly mean by that? A certain command?

When I issue the g28 command, the clipper closes as the axes move to the zero position.

I tried but it closed again, it caught my attention. It closes in the z_safe_home command, when I comment ‘‘z_hop’’ it goes back to normal, when I open ‘‘z_hop’’ again, I have a problem klippy (4).log (250.8 KB) moonraker (3).log (19.6 KB)

‘‘BLTouch failed to verify sensor state’’ now i faced this problem

Sorry, no further idea. You basically have two dimensions: The config These ratos configs are pretty complex and involved. If I had this problem, I would start with a minimum config that only contains what is necessary to print → No LEDs, Macros other bling bling The hardware The “Timer too close…

i think i need to re-install a mainsailos and make a printer as simple as possible, i just need support to prepare the printer.cfg file

Try printer.cfg (3.6 KB) This should be your config stripped to the bare minimum needed to print. Fun fact: Needed for printing: 230 lines of config RatOs config: 1211 lines

Clipper shuts down when i send it home

General Discussion

Sineos March 21, 2023, 8:45am 4

See Timer too close

First thing I’d try is to remove the webcam.

Topic		Replies	Views
Won't home , MCU 'mcu' shutdown: Timer too close General Discussion	2	492	April 29, 2023
Klipper keep shutdown General Discussion	1	67	December 16, 2024
Config file issues? General Discussion	1	57	March 13, 2025
Shut Down of Klipper by z-homing General Discussion	2	597	February 2, 2023
Mcu shutdown: Timer too close General Discussion	8	798	July 29, 2023

Clipper shuts down when i send it home

Related topics