Basic Information:
Printer Model:
MCU / Printerboard:
Host / SBC
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
I bought a fully functioning Ratrig 3.1 with a Euclid probe. When I got it home I was not able to access the user profile so I redid it from scratch. When I am in Mainsale the Ratrig will zero out the XYZ successfully.
I went to the console and executed the probe_calibrate , z offset is 5.9. I saved and restarted.
When I attempted a test file from Prusa slicer it drove the head down onto the plate each time, not stopping when the sensor lights up. I receive the following error message,
Error evaluating ‘gcode_macro PROBE_FOR_PRIMING:gcode’: gcode.CommandError: Horizontal move Z ({z}) is below your probe’s Z offset ({z_offset}). Please adjust your horizontal_move_z setting in [bed_mesh] to be above {z}.
Suggestions?
Keith
…
klippy.log (4.2 MB)