Basic Information: Printer Model: Ender 3 MCU / Printerboard: v1.1.4 Host / SBC Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “Knowledge Base” Category first. Most relev…

[image] chintu: This is how I soldered it up ↓ Does it work? Typically this board uses following connection scheme: [bltouch2a]

any help appreciated. i dont mind soldering. I dont want to buy a new board.

This is how I soldered it up ↓ [image]

Yes, but I didn’t want to remove the beeper. It works great. [IMG20240923045112] Next tackling input shaping. :slight_smile:

CR touch wiring and Config for Ender 3 v1.1.4

Sineos September 22, 2024, 3:32pm 7

Does it work?

Typically this board uses following connection scheme:

Topic		Replies	Views
Unable to run bl touch on my ender 3 with v1.1.4 General Discussion	6	1264	September 22, 2023
Ender 3 pro v1.1.4 main board + Bltouch General Discussion	3	3602	May 5, 2024
3DTouch probe not working with Ender 3 General Discussion	10	1190	May 5, 2024
Help on old Ender 3 1.1.3 General Discussion	3	85	May 28, 2025
Bltouch BTT skr mini e3 v3 General Discussion	6	361	June 28, 2025