Ender 3 pro v1.1.4 main board + Bltouch

General Discussion
1

Getting Klipper setup on Ender 3 Pro with 1.1.4 board and BLTouch 3.1. I am having trouble with the bltouch when homing. It will move to start homing and then probe wont deploy at all. I get a message of “BLTouch failed to verify sensor state”
On start up it will make blt self test. Lcd also not workink maybe someone has creality 1.1.4 board pinout? Dow i put my printer config
printer.cfg (9.1 KB)

2

I had the same problem with the 3DTouch 2. I switched to BLTouch 3.1 and it worked without issue.
SKR PRO V1.1

3

See BL-Touch - Klipper documentation, especially the sections: