Does anyone know why my newly installed klipperscreen is flipping to the print list menu?

[Schuessel]

Hi,
i think that is the same Problem that triggers the Display-Points like in this case:

Klipper auto starts printing after a print finish

Hello, Im new to Klipper and I’ve installed a Manta M5P with CB1 into my Anycubic mega pro. after doing my research before installing the board I set Klipper up and learning it. After installing it I didn’t get any errors just had to flip 2 motors. so I go lucky. But what I’m having a problem with is. After a print finish the printer starts up again and starts printing again. I can’t find anything on this. Im using the default end_print code. but added a few lines. What am I over looking or a…

since it is the same Area that must have been triggered.

I’m not sure but i think i’ve seen that after a while in standby on my Printer too.
Looks more and more like there is a Problem with the Manta-Boards and the BTT-tft35.