Dual extruder sharing sensor and heater

General Discussion
1

Basic Information:

Printer Model: BTT M*P V2
MCU / Printerboard:
Host / SBC
klippy.log
I have a dual extruder that shares a hot end and thermister. I have tried every configuration and I keep getting errors, “must assign heater pin in extruder1”, too many heater_pin: PA0 entries. I just would like to find a configuration that works

2

grafik
grafik1246×134 12.2 KB

Please attach the klippy.log to your next post.

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.