Ender3 V2 is not connect as mcu to klipper

General Discussion
1

Basic Information:

Printer Model: Ender 3 V2
MCU / Printerboard: Creality Ender 3 V2 V4.2.2 Silent
Host / SBC: Raspberry pi 5
klippy(2).log (150.2 KB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Hii i had downloaded klipper on my raspberry pi 5 but every thing is setup perfectly but its not detecting the mcu

2

Hello @mrsonsare !

That is a wide expression.

Did you follows some guides or did used some tools?

3

yes i had try many
but evry thing seems to be right

4

And which ones?

5

image
image598×664 46.6 KB

6

And have you flashed the MCU?

You still did not tell what guide/tool you used to install Klipper (links please)

1 Like
7

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.