Endstop relative position/Homing issue

[megatots]

Describe your issue:

Hello I just got a sonic pad and the homing axis is stuck moving to the same direction regardless if I change the config and I’m not sure why.

I ran STEPPER_BUZZ STEPPER=stepper_x/y/z and see that the x axis is moving left, y axis is moving towards me, and z axis up. My home location should be on the upper right though so the home is moving in the wrong direction on the x and y

Printer: Ender 5 pro w/ mainboard 4.2.7 & CRTouch

[EddyMI3D]

Hello @megatots !

@megatots

I just got a sonic pad

Sorry to say: We do not provide support for the Sonic Pad.

Creality Sonic Pad and Alternatives

Creality Sonic Pad Update Since July 11, 2023, Creality seems to have released a firmware with a newer Klipper version. Again, they have not released the sources for this and the other components as required by the GPL license. Again, they are violating the OSS license and making money off the work of others. Background The Creality Sonic Pad is intended to be a “one-stop” solution for Klipper. A SBC running Klipper along with Moonraker, Fluidd, Mainsail and KlipperScreen A …

Please consult Creality support

[megatots]

No worries. I was able to figure out the issue,
for anyone else reading, modifying the cfg that was flashed into the sd card didn’t work for adjusting the endstop position. I had to connect to the web interface and change the cfg that way to get it to work correctly