Error on command REMOVE_MCU_RPI_CONFIG

General Discussion
1

Basic Information:

Printer Model: Modded ender 3 pro
MCU / Printerboard: Skr E3 V3
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

… So i’m having this issue right here, built klipper for the sonic pad since my moba wasn’t supported by default, all other calibrations worked flawless, only when trying to measure resonances from the sensor attached to the pad, in the end when it wants to save the measurament it gives me this strange error, could’t find anything about it on the internet. if someone could help that would be super.

2

Hello @Lumaca

This to your info:

1 Like
3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.