Extrude below minimum temp after PID

General Discussion
1

Basic Information:

Printer Model: Ender 3
MCU / Printerboard: Voron mini E3
klippy (3).log (790.9 KB)

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

new to klipper, completed PID tune of heater extruder and bed and still getting error message: “extrude below minimum temp”. Backstory: bought printer used with raspberry pi, klipper, moonraker and fluidd UI. After doing update, I lost entire configuration so starting from scratch. Complete rookie to 3D printing besides sending gcode file to fluid and selecting print
…

2

You are trying to start a print with a cold hotend and this is leading to this error.

Make sure to have the correct stamens in your slicer’s starting gcode to set bed and hotend temperature.

1 Like
3

Thank you for the feedback.
I am using super slicer and did not think any code was lost from the slicer itself. I will have to look into this.

4

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.