"extruder" not hot enough/Extrude below minimum temp

General Discussion
1

Basic Information:

Printer Model: Biqu BX
MCU / Printerboard: SKR SE-BX v3.0
Host / SBC: BTT Pad-7
klippy.log (4.1 MB)
Double_Spiral_Vase2_3h1m_0.80mm_245C_ABS_BIQUBX.gcode (3.5 MB)

klippy.log

Hi,
I’ve been in and out of the hobby and now I’ll give it another shot his time with klipper. I chose Prusa as my main slicer and I was not able to start a print yet. Everything goes ok until right after the bed mesh an d than it just stops with the “extruder” not hot enough error.

Can anyone please give me a hand?

2

config-20240618-173301.zip (4.4 KB)
Here’s my config file

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.