Basic Information: MCU / Printerboard: SKR-mini-E3-V3.0.1 Host / SBC: Orange Pi2 klippy.log __ __ _ _ _ ____ _____ | \/ | (_) (_) |/ __ \ / ____| | \ / | __ _ _ _ __ ___ __ _ _| | | | | (___ | |\/| |/ _` | | '_ \/ __|/ _` | | | | | |\___ \ | |…

A couple of things I found are important when Flashing new Firmware onto a main controller board: Ideally use an SD Card that is no more than 2GB in size. This is the most basic type of SD Card and is most likely to be read without problems on the SKR Mini. If you don’t have an SD Card that size…

Welcome chiboreache, I agree, you have indeed a STM32G0B0 on your SKR, but in your build config (line 3 of your posted code) you chose [image] chiboreache: MCU=stm32f401xc Good luck, hcet14

i have tried a lot of configs, B0, B1, after that i started using precompiled ones, result is always the same :pensive:

Did you try to install Klipper using KIAUH ? You may read Sineos Installing Klipper with KIAUH I guess lwq690 solved that with No firmware for STM32G0B0RET6 ? · Issue #775 · bigtreetech/BIGTREETECH-SKR-mini-E3 · GitHub

[image] hcet14: solved by buying new board with right processor !? :hot_face: i installed it via MainsailOS, which is included KIAUH, doing all that stuff, yeah

[image] chiboreache: by buying new board with right processor !? :hot_face: Why would you buy a new board? I never suggested that! [image] chiboreache: i installed it via MainsailOS, which is included KIAUH, doing all that stuff, yeah Did you try lwq690’s settings? [image] hcet14: …

you absolutely right (but i figured it out by myself :yum: ) i used 32Gb card for SKR and 8Gb for OrangePi, now i swapped them and reflashed accordingly and everything is working like a charm :ok_hand::relieved: i think this essential knowledge should be added to docs with red frame around, since …

and one more thing which config is better SKR-mini-E3-V3.0-klipper.cfg or generic-bigtreetech-skr-mini-e3-v3.0.cfg ? for Ender3 (basic)

oh, my bad, i’ve got confused :smiling_face: it was BTT docs thanks!

Flashing process issue

General Discussion

hcet14 October 17, 2024, 7:36pm 10

It is documented Releases - Klipper documentation

Support for stm32f7, stm32g0b0, stm32g07x, stm32g4, stm32h723, n32g45x, samc21, and samd21j18 chip variants.

Topic		Replies	Views
Unable to flash Klipper in Skr mini e3 v3 General Discussion	12	356	November 5, 2025
Flashing Klipper.bin to BTT SKR Mini E3 V3 General Discussion	38	9740	May 18, 2025
Can't get skr e3 v3 bootloader working General Discussion	4	796	April 6, 2024
SKR Mini E3 V3.0 MCU problems General Discussion	8	6654	May 5, 2024
Flash-sdcard.sh fails in recent releases General Discussion	4	185	April 19, 2025

Flashing process issue

Related topics