As usual Fysetc documentation is a real sh**!!! Suposedly this board “for Voron 0.2” has onboard Canbus and fystec says it has a STM32F401RCT6 processor but if I select STM32F401 when building klipper I do not see option to canbus bridge as interface comunication.
I Also can not find in fystec documentation wich pins they suposodly use for canbus
can anybody run this board with canbus or have any other info wich can be useful?
Best Regards
I have not used my board yet, but the schematic is very clear that the CAN port is run directly by the Linux host processor and not via the printer controller.
I would expect the interface to be available for use in the Linux system already.
The board looks fine to me, but I’m worried about using a different Linux distribution.
I had ordered the 0.2 kit and they ‘upgraded’ me to the 0.2R1.
This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.