Basic Information: Printer Model: Voron 2.4 350 MCU / Printerboard: BTT Octo Host / SBC Pi4 Describe your issue: Hi all i have switch to Orca slicer, slicing there and sending to Voron no issue. since switching to orca slicer i now have constant unknown command G2 and G3. I believe this is a f…

Why do you want to use G2 or G3? It does have its uses and advantages but for normal 3d printing it is minimal. Apart from the shorter traveltimes it has little improvement on the 3d printing process. Basically pooing a blob of plastic on another blob of plastic, so the accuracy of arcs is not reall…

I do t want to use it but for some reason orca slicer won’t slice without using it! So I’m trying to find a want of either getting rid of arc or config Voron to use it. I am not sure on how to implement the arc configuration for Voron. The above like show it but how do I use it?

[image] Arc fitting disabled in orca, but receiving unknown command G3/G17 errors General Discussion Basic Information: Printer Model: Troodon 2 Pro MCU / Printerboard: STM32F407 Host / SBC Raspberry Pi klippy.log klippy (2).zip (1.1 MB) Fill out above…

[image] Jateu01: I believe this is a firmware setup Depends on your point of view. Orca has by default “gcode arcs” enabled, while Klipper has not. IMO, this functionality is not needed for Klipper and on the contrary potentially detrimental. I suggest turning it off in Orca.

Help With Voron 2.4 G2 and G3 Unknown commant

General Discussion

3dcase November 1, 2024, 4:47pm 4

Maybe you will find an answer in this article.

Topic		Replies	Views
Arc fitting disabled in orca, but receiving unknown command G3/G17 errors General Discussion	19	5122	October 14, 2024
Unknown command G2 and G3 General Discussion	4	17169	June 13, 2021
Arc movement: (G2, G3) Features	3	30127	July 6, 2021
The Myth of G2 / G3 Arc Commands Knowledge Base	0	1153	July 23, 2025
Internal error on command:"G2" General Discussion	10	1014	December 12, 2023

Help With Voron 2.4 G2 and G3 Unknown commant

Related topics