Homes, warms the noz/bed, but won't print

General Discussion
1

Basic Information:

Printer Model: Anycubic Kobra (1) Max (Catboat ver. of Klipper)
MCU / Printerboard: BTT Pi / TriGorilla
klippy-7.log.zip (870.9 KB)

I do have some experience with Klipper, but not with this printer…just getting it dailed in. When I try to send a bed level file to the printer, it homes, lifts and waits for temp, but never proceeds from there. It just sits there above the print bed and holds temp.

2

Looks like your extruder has difficulties to maintain the target temperature.
Did you perform a PID tuning?

3

I did last week, but I’ll do it again. Thx for the recomendation.

4

ran PID tuning, and now it gets ferther in the prince process, but it gets a move out of range. I don know how, in the middle of a 410mmx410mm printer you could be out of range, but whatever. I am working on that now.

5

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.