Anycubic Kobra max + btt pad7 print wont start

General Discussion
1

Basic Information:

Printer Model: anycubic kobra max
MCU / Printerboard: stock
klippy (1).log (1.9 MB)

Describe your issue:

So I just started klipper adventure yesterday, I got everything set up and the pad 7 is controlling all functions and running great. I tried to run a test cube to check on calibrations and nothing happens. The printer heats up and homes all axis then parks the nozzle in the front left corner and just sits there and never starts. I can’t seem to figure out why this is happening, the console in the browser only says 10:52 AM
File selected
10:52 AM
File opened:test cube.gcode Size:215284
but nothing seems to happen… I added custom code to cura start and end and disabled the coasting and jerk settings for cura.
…

2

Please upload your klippy.log file here. It will assist in troubleshooting and might have the answer for what is happening.

3

I attached it to the post when i made it. I am not 100% what changed, but I did get it working. I forgot to update my post.

4

Restart the Klipper service with:

sudo systemctl restart klipper.service

Followed by a FIRMWARE_RESTART in the printer’s console.

5

Oops, my bad! I missed that.

Great to hear it’s working, enjoy!