Homing - "MCU 'mcu' shutdown: Timer too close" - CTC13 (Anet A8 Board)

General Discussion
1

When trying to perform a homing action the Z axis moves 10mm then throws a Timer too close error

Klipper is running on a Raspberry Pi 3B

Unfortunately unable to use printer due to this issue, tried homing both a single axis and all axis but with the same result

Any help would be appreciated
klippy.log (968.2 KB)

2

You have a whole lot of different errors in your log. This may indicate an unstable RPi, e.g.:

  • bad cabling, e.g. USB
  • fishy SD card
  • unstable power supply