Take this with a large grain of salt, this is what someone else posted in a previous thread.
#inductive probe settings
[probe]
pin: PA1
x_offset : 24.0
y_offset : 13.35
#z_offset: 0
samples: 3
samples_result: average
samples_tolerance_retries: 1
sample_retract_dist: 2
speed: 15
lift_speed: 8
samples_tolerance : 0.1
samples_tolerance_retries : 3
Previous thread
It says Plus/Pro/Max but I believe they all fundamentally use the same sensor.
It says inductive but the so did the Anycubic Vyper I played with it and it was strain gauge based so who knows on that.