I tried to have a go at this but I couldn’t. I need a macro that can output the value of z_tilt_adjust or the values of stepper_z and stepper_z1 after I home the printer. I’d like to establish if the G28 commands overwrites the values that z_tilt_adjust provided.

Thank you! I tried it, but it doesn’t output values of z_tilt_adjust.

Is it possible to output `z_tilt_adjust` value?

Sineos March 16, 2023, 8:47pm 2

Topic		Replies	Views
Z_tilt_adjust --> store Z adjustments General Discussion	7	6022	March 22, 2023
Klicky probe Z tilt adjust macro General Discussion	0	173	December 24, 2024
Z_TILT_ADJUST behaviour General Discussion	3	1041	June 17, 2024
Z_TILT_ADJUST results in incorrect z offset General Discussion	11	867	April 13, 2025
Problem with Z_TILT General Discussion	4	4437	January 11, 2023