Can the new kobra 2 run klipper natively? Or did anycubic use the same motherboard as the other kobra models?

Hi, I’ve looked at the log and don’t see anything obvious. Basically it tries to turn on the heaters (fans do get switched on) but there’s no increase in temperature so errors with (e.g.) “Heater extruder not heating at expected rate”. This is a section of the log from when it fails, I have tried …

[image] EddyMI3D: Any klippy.log? That meant: Please upload the klippy.log. As file. [Upload] And please, when you upload code as text, please use the code brace for a proper output: [Format]

OK, thanks, as I said new to Klipper. Anyway, have found the answer, the POWER_CTRL_PIN (PB4) needs to be set high.

Hi Fragmon, what config did you use to install Klipper on the Kobra 2? Complete klipper-newbie here…

Hi, did you already found a .cfg for Kobra2 ? I´ve bought the Sonic-Pad, but I am not able to connect it without a config-file.

Hello @Frano83 [image] Frano83: I´ve bought the Sonic-Pad Bad choice: [image] Creality Sonic Pad and Alternatives Knowledge Base Creality Sonic Pad exclamation Update Since July 11, 2023, Creality seems to have released a firmware with a newer Klippe…

What Pins do you Set for the serial for the klipper.bin

I am using already a Mega S with Marlin and Octoprint. Now I have bought a new Kobra2 printer and thought, that the sonic pad would be an easy way to use Klipper.

I have stopped the installation of the pad, when I saw that the printer-config was not available.

How do you do that? Can you explain this`?

Klipper install Anycubic kobra 2

General Discussion

EddyMI3D July 17, 2023, 3:05pm 19

Hello @Frano83

Bad choice:

Topic		Replies	Views
Getting orange pi 3 lts + klipper working with anycubic kobra 2 neo General Discussion	233	12073	April 11, 2024
Anycubic Kobra 2 Pro/Plus/Max + MKS Robin Nano v3.1 = native Klipper General Discussion	36	4335	June 4, 2024
Anycubic Kobra Max config file Configs	162	23217	November 3, 2025
Anycubic kobra 2 neo v0.7.3.5 configs + OrcaSlicer profiles Configs	57	15098	August 12, 2024
Anycubic Kobra Neo - Connection issue General Discussion	47	1121	April 25, 2025

Klipper install Anycubic kobra 2

Related topics