Just to be on the same page: KlipperScreen is the menu that is displayed on the touchscreen once it is running. There is no “go into”
As I do not have this device I would recommend:
- Follow the setup instructions as shown in the manual from page 12 and following → This will provide you with a working base configuration
- Read through Klipper Architecture / Ecosystem to get an idea how Klipper works
- Configure your system according to your needs (this is not done by Pad 7 as it is a “multi-purpose” device):
- printer.cfg → Installation - Klipper documentation (skip the part about Octoprint)
- KlipperScreen
- Moonraker (likely not much to do there as the default setup should give you a working version already)
- https://docs.mainsail.xyz or https://docs.fluidd.xyz/