Basic Information: Printer Model: anycubic kobra 2 neo MCU / Printerboard: GD32F303 Host / SBC: Mainsail (i think this goes here) klippy file is replies couldn’t post as new user Describe your issue: after discovering this amazing website: Klipper (MOD) - Kobra2Neo Insights forced me to deep…

I’d suggest to start over with a default, stable Debian like distribution, e.g. Debian, Ubuntu etc and then painstakingly follow the instructions for this board and the pointers given in the above link.

Klippy log file klippy.log (73.9 KB)

[image] EthanD: if i type the command “ls /dev/serial/by-id/*” i get a response of no such file in directory. and im pretty sure this means printer not conneceted. so now what? Likely your board is not correctly flashed. See Issues flashing the printer board

Hey @Sineos , i think i have read that page like 100 times LMAO thanks for the useful guide but i have followed the steps to the millimetre with so many different firmware still nothing working. Thanks for your response tho.

Eyyy it worked thank you so i just gotta figure out how to acutally print LMAO.

Kobra 2 neo potential usb problems

General Discussion

Sineos April 8, 2024, 12:56pm 5

Likely your board is not correctly flashed. See Issues flashing the printer board

Topic		Replies	Views
Printer is not ready The klippy host software is attempting to connect General Discussion	6	213	May 6, 2025
Unable to connect to mcu on kobra 2 General Discussion	6	141	October 17, 2024
MCU Connection Error, Kobra 1 Plus, TriGorilla ProB General Discussion	10	357	December 31, 2024
Anycubic Kobra Neo - Connection issue General Discussion	48	767	April 25, 2025
Kobra 2 Trigorrila pro b v1 0.2 General Discussion	13	773	January 26, 2025

Kobra 2 neo potential usb problems

Related topics