Kobra plus flash. What am I doing wrong

General Discussion
1

I’m getting a make error “no rule to make target ‘flash’. I have followed the instructions best I know. “I’m new and I don’t know what to do”-Joe dirt…. Anyways I have ls /dev/serial/by-id/* which gives me /dev/serial/by-id/usb-1a86_USB_Serial-if00-port0. I’ve tried loading other people’s firmware to the printer which makes it beep and disables the Kobra screen but when I ssh into the raspberry and bring up mainsail and fluidd I can’t get it to connect. I’m stuck at this point. If anyone has gotten the Kobra plus to work with klipper save a drowning dude. Cause at this point I’m up shit creek without a boat trying to balance myself on the paddle. I’m lost. Need anymore docs let me know
Printer Model: Anycubic Kobra Plus
MCU / Printerboard:
klippy.log

Fill out above
klippy.log (101.8 KB)
moonraker.log (413.8 KB)
information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…strong text

2

Quite strange but given that your entire config is completely borked I’d strongly recommend to start over:

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.