Hello sir,
I don’t think I explained my point clearly enough:
- I followed the link you provided and even contacted the person who posted it for support.
- For my wiring, orange on 13 and white on 6, plus the 3D Touch was working perfectly on the Marlin firmware, so the possibility of a defective BL Touch or bad wiring is unlikely.
- As I mentioned, when I supply the machine with current, the BL Touch goes out and in twice by itself. On Marlin, this indicates that the BL Touch is functioning correctly.
- For the config file, I tried several combinations, but as you see, I didn’t get any results.
last log file
klippy (5).log (871.0 KB)
my cfg file
printer (5).cfg (2.2 KB)