MCU 'EBBCan' shutdown: ADC out of range

[EddyMI3D]

For you have the PT1000 connected to the EBB (in the beginnig of the log it was directly connected to the MCU and caused the same error), you should deeply investigate that part. May try with a different thermistor.

ADC out of range

ADC out of range Background A thermistor has reported a temperature outside of the specified limits Reasons Specified min_temp / max_temp in the respective heater section has been violated Damaged or faulty thermistor or thermistor cables Potential solutions The error message does not contain the offensive heater. This needs to be analyzed in the klippy.log. Make sure to specify workable limits for min_temp / max_temp for the given heater. They shall reflect sane limits since this is a “…