MCU not detecting USB cant get it to work and troubleshooting was too vague

General Discussion
1

Basic Information:

Printer Model: Ender 3v2
MCU / Printerboard: Creality Stock 4.2.2 Motherboard
Host / SBC Raspberry Pi 3b+

klippy (9).log (898.4 KB)

klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…

2

That title is too vague to make a statement.

And your description also.

3

I vague-ured it out myself

4

And so? What was it?

5

I had to choose the serial option rather than the USB option. Then, had to remake the bin file and make sure the name didn’t match the previous. Used my good USB. Then, it just booted right up.