Mcu timeout during servo deploy

General Discussion
1

Basic Information:

Printer Model: Ender 5 plus (modified)
MCU / Printerboard: Octopus 1.1

Hi, i wanted to reply to this topic but is closed:

Problem MCU is shutting down during servo deploy of clicky probe connected to BLtouch connector. I think i found a solution to this problem:
Servo seems to turn very fast and it propably causes some voltage drop.
A solution was to add 10 ohm resistor to +5 voltage cable to decrease servo speed. Since then everything has been working as it should.

2

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.