Move Z before homing feature

General Discussion
1

Basic Information:

Printer Model: LDO Trident 300
MCU / Printerboard: LDO Nitehawk
Host / SBC
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

…
Hi all,

In the past when homing X, Y or both the Z will move down before moving the probe which is extremely useful as clearance but now it has stopped. I am not very good at looking at the printer.cfg but I am wondering if anyone know what I need to add where to bring this feature back?

2

Hello @Ho-Whizzle !

So you have been asked to provide the klippy.log:

grafik
grafik813×376 15.6 KB

Please attach it to your next post.

1 Like
3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.