Klack ender homing error

General Discussion
1

Basic Information:

Printer Model: ender 3 pro
MCU / Printerboard: skr e3 v2
Host / SBC pi 4
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Only when homing when the probe goes to re dock after recording the z value instead of rising off the bed it tries to dig down into the bed causing the z stepper to stall out any ideas?
printer.cfg.txt (18.2 KB)

…
klippy.log (1.5 MB)

This is my Reddit post containing more info: Reddit - Dive into anything

2

That is one sentence? Hard to understand.

Sorry, Reddit is blocked here.

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.