My steppers are hella loud after installing klipper

So I just installed klipper on my ender 3 (with an skr 2), but instantly found out that for whatever reason my steppers are extremely loud. Before this I was using an skr mini e3 v1.2 and it was really quiet, but no more. Does anyone know how i could fix this?

printer (2).cfg (5.7 KB)

since I can’t upload video here:

edit: someone on reddit mentioned you can just enable stealth chopping…

I did that too with stealth chopping.

My setup for x:

[tmc2209 stepper_x]
uart_pin: PB3   # MISO 4 Wire
#tx_pin: 
uart_address: 0
interpolate: True
run_current: 1.35
#hold_current: 1.1
stealthchop_threshold: 999999