No Activity from Pi 3B+ after Powercycle

General Discussion
1

Hello, I’m new here. Today I managed to install Klipper with Fluidd on my Pi and my Cr-10s. I’m not good at this and YouTube and Forums like this one helped my a lot (Thanks by the way). I did my first Testprint and everything worked fine until I shutdown the Pi. Now when I power it up nothing happens. The red LED lights up but the green Activity LED does nothing and I cannot find it on my Network either. The Pi worked with Octoprint for more than a year. And my PC can read the MicroSD card with Klipper/Fluidd with no problems. Any Ideas?

Thank You
Maurice

2

Software shutdown or pulled the plug?

3

I use the Software shutdown. And after 1-2 Minuten i use a smart WiFi Plug to kill the power from the Pi and the Printer at the same time.

4

You may connect an HDMI TV or monitor to the Pi to see what is going on during startup.

5

A new SD card and a fresh install did the Trick. Today i noticed same weird behavior when plugged to my PC. I thing the old Card is dying. Despite this thank you for your help.

1 Like