Option 'step_pin' is not valid in section 'stepper_z2'

General Discussion
1

Basic Information:

Printer Model: Eustathios Spider V2
MCU / Printerboard:SKR 1.3
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Is it possible to use E1 as my second Z stepper?

I keep getting this error:

Option ‘step_pin’ is not valid in section ‘stepper_z2’

klippy.log (108.5 KB)

2

Hello @bcrazycramer !

Your second Z stepper is z1, not z2.

3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.