Basic Information: Printer Model: K1 MAX MCU / Printerboard: Host / SBC klippy.log Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed Be sure to check our “Knowledge Base” Category first. Most …

Thank you for the reply, appreciate you looking into it. I did manage to solve the issue though. The printer was attemping to move outside the printer movement limits (296.192) i changed the printer limits in the config file to (297) and has resolved the issue

Persistant move out of range error

General Discussion

EddyMI3D December 15, 2024, 7:52am 2

Hello @bad_printer !

This is quite hard to tell, because the klippy.log does not adhering to the genuine Klipper conventions.

Topic		Replies	Views
Move out of range: 5.000 -20.250 5.000 [0.000] General Discussion	5	102	September 26, 2024
Move out of range: 150.000 0.000 10.000 [20.000] General Discussion	6	148	June 5, 2024
Klipper says "move out of range" on any move General Discussion	9	2651	September 4, 2024
Move Out of Range - Mid-Print. Y or [E] values seem off General Discussion	2	25	December 22, 2024
End of print error -- out of range General Discussion	6	654	June 12, 2024

Persistant move out of range error

Related topics