Fill out above information and in all cases attach yourklippy.logfile. Pasting yourprinter.cfgis not needed
Describe your issue:Klippy.log wont upload it says it is too large. Basically any time I try and print the PA test stl using the tuning tower commands listed in the documentation ‘TUNING_TOWER COMMAND=SET_PRESSURE_ADVANCE PARAMETER=ADVANCE START=0 FACTOR=.005’ I error out. I receive the error unable to infer active extruder stepper. I have tried every way I can think of to include the stepper in the tuning tower command with no luck. Basically I just need to know how to run the tuning tower command and tell Klipper what stepper is active.