Printer drives without braking into the end stop x-axis y-axis

General Discussion
1

Hello everyone,

I think I read it somewhere at some point, but I can’t find it anymore.

I have the following problem, my Anycubic Kobra plus (clacked)  moves without braking when I let it home or pause, almost unbraked in the x and y axis so that it bangs properly.

So of course I get a great offset.

I mean somehow I can let it slow down beforehand, and I think that was also somewhere in the cfg file.

Would be great if you could help me as always. :see_no_evil::+1:

Greetings Digedi

p.s. otherwise it runs great.
klippy.log (5).txt (6.4 MB)

2

grafik

3

@EddyMI3D → the “Klipper.log” is now a very fresh one right after you turn it on…I hope that does the trick.

Best regards
Digedi

4

It appears you are using a Creality Sonic Pad.

You may have a look on this: