Problems configuring an ADXL345

General Discussion
1

Basic Information:

Printer Model: Ender 3
MCU / Printerboard: Creality 4.2.7

klippy.log (1.8 MB)

Describe your issue:

I’m having trouble configuring an ADXL345. When I try to add the configurations to the printer.cfg file, it says that the SPI_BUS is not recognized. I’ve already checked the microcontroller’s configurations (in my case, an Orange Pi Zero 2W), and SPIDEV0.0, 1.0, and 1.1 are all enabled, but it doesn’t recognize any of them.

image
image829×287 7.79 KB

…

2

You need to add the GPIO pins of your host as a (virtual) MCU.

1 Like
3

This topic was automatically closed 60 days after the last reply. New replies are no longer allowed.