MCU 'rpi' error during config: Unable to open spi device (CB1)

General Discussion
1

Basic Information:

Printer Model: ender 3
MCU / Printerboard: CB1 / bigtreetech manta e3ez
klippy.log klippy.log (16.8 KB)

Hi all, I have a problem with adxl345 (right now I’m just getting my printer ready to work with it, because I don’t have it on hand)

Снимок экрана 2024-02-04 132500
Снимок экрана 2024-02-04 132500894×284 9.47 KB

when trying to run with this config
adxl345.cfg (288 Bytes).
I figured out that the error is caused by [adxl345].
what am I doing wrong?

2

The file adxl345.cfg does not appear within your sprinter.cfg.
Neither with a [include] command nor as code.

Are you sure the klippy.log is recent?

The error does not appear inside the log.

3

HI
I did a little tinkering with the settings and now it looks like this:
klippy (1).log (218.6 KB)
image
adxl345.cfg incluв in printer.cfg

4

if i raplace ‘gpio74’ with ‘None’, it doesn’t go into error.