Problems with auto-leveling and changing layers, Anaconda

[Anelsa]

Basic Information:

Printer Model: Anycubic Kobra NEO 2
MCU / Printerboard: BIGTREESTECH-SKR MINI E3 V3.0
Host / SBC: Orange Pi Zero 3 4GB
klippy(3).log (5.1 MB)

3DBenchy-0.2-50m.gcode (2.4 MB)
printer.cfg (5.3 KB)

Hi there.
I have problems with auto-leveling and changing layers. The bed grid is constructed using BQ MicroProbe, deviation 0.267 (5x5).
When I start printing, the printer ignores the elevation map, the nozzle sticks into the table and scratches it. I thought that this was a problem of inaccuracy in the construction of the table with an induction sensor, I changed it, the problem remained

Now that the printer has switched from the standard Anycubic Trigorilla board to the SKR MINI E3 3.0, the printer does not change layers during printing, it continues to print all layers, roughly speaking, in Z0.

How can I fix ignoring the auto level and return the layer change? Thank you in advance.

[EddyMI3D]

Have you done this?

https://www.klipper3d.org/Probe_Calibrate.html#calibrating-probe-z-offset

[Anelsa]

Hi, I think not. I’ll try it now

[Anelsa]

Thx dude. Now everything is back to normal