Basic Information:
Printer Model: Kobra2 Neo
MCU / Printerboard:
Host / SBC
klippy.log
Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there
Describe your issue:
…Hello everyone😊 I’m new to the forum and needed help with Klipper.
My 3D printer is a Kobra2 Neo, and I’ve already configured Klipper. I’m using the ready-made Printer.cfg and macros from this forum. I don’t know what I’m doing wrong, but my first layer keeps changing. Sometimes it’s too high, sometimes too low. I don’t have this problem with the original firmware; once the Z offset and bed leveling are done, everything works perfectly. I have a few questions:
- Probe_calibrate at room temperature?
- Bed mesh before or after? (At print temperature or at room temperature)
- How long should I preheat the print bed before printing?
Can someone help me with the calibration up to the first layer so I can get this under control? I’m reluctant to go back to the original firmware because I really like Klipper.