Basic Information: Printer Model: Prusa i3MK3S+ MCU / Printerboard: Einsy Host / SBC RPi 5 klippy.log klippy.log (857.5 KB) Describe your issue: I performed a PID calibration on the E3D 0.4mm High Flow nozzle using: PID_CALIBRATE HEATER=extruder TARGET=230 SAVE_CONFIG Then I performed a P…

Hi @printeruser , This typically happens when there’s a line like this in your SAVE_CONFIG section. #*# [heater_bed] #*# ... #*# control = watermark Can you try replacing the last line with: #*# control = pid

Which file is that? In my printer.cfg, under the SAVE_CONFIG section at the bottom, I only have: There is no heater_bed section. #*# <---------------------- SAVE_CONFIG ----------------------> #*# DO NOT EDIT THIS BLOCK OR BELOW. The contents are auto-generated. #*# #*# [extruder] #*# control = pi…

[image] printeruser: Which file is that? There is no separate file where the config_block is stored. [image] printeruser: SAVE_CONFIG section ‘heater_bed’ option ‘control’ conflicts with included value For this error, not heater_bed section is stored in the config_block. It has been …

Enclosed is the printer.cfg file under printer_data/config/. Thank you printer.cfg (7.1 KB)

[image] Sineos: See SAVE_CONFIG section ‘bltouch’ option ‘z_offset’ conflicts with included value And again. See the description in the link. You have relevant parameters (in this case, regarding the heated bed) in an included file, and Klipper cannot update them on a SAVE_CONFIG command.

How to revert the change properly? Is there a command on the Console that can do that? Heatbed PID is not so important to me so I don’t have to do it. What is the reason that Klipper cannot update them on a SAVE_CONFIG command? Anyway, thanks for your direction. I found a block of heater_bed rela…

[image] printeruser: Is there a command on the Console that can do that? No, the error is caused by the way the configuration is structured and set up. How should a “console command” fix this? [image] printeruser: Heatbed PID is not so important to me so I don’t have to do it. It shou…

Thanks for checking. In regard to those messy configurations you mentioned, they were all made by the developers of: dz0ny/klipper-prusa-mk3s: Structured Klipper config for Prusa MK3s 3D printer Before I installed Klipper, I asked around and some Prusa users recommended that site probably because…

Well, it takes some experience and a lot of reading to fine-tune a Klipper configuration. As such, starting with a pre-made one absolutely makes sense. Some are better than others, and some decisions depend on personal preferences. Personally, I loathe the almost neurotic usage of includes, as they…

Save_config section 'heater_bed' option 'control' conflicts with included value

General Discussion

Sineos May 7, 2025, 8:33pm 3

See SAVE_CONFIG section 'bltouch' option 'z_offset' conflicts with included value

Topic		Replies	Views
SAVE_CONFIG section 'extruder' option 'control' conflicts with included value General Discussion	7	8247	November 11, 2023
Issue with PID_CALIBRATE / heater_generic / SAVE_CONFIG General Discussion	4	590	March 6, 2024
Can't save hotend PID autotune after deleting from bottom of printer.cfg General Discussion	10	2819	October 25, 2024
Startup error General Discussion	4	155	March 29, 2025
Direct Acting Bed PID General Discussion	39	1024	April 18, 2024

Save_config section 'heater_bed' option 'control' conflicts with included value

Related topics