Save_variables not works

General Discussion
1

Basic Information:

Printer Model: Ender3
MCU / Printerboard:BTT Manta E3EZ
klippy.log

Fill out above information and in all cases attach your klippy.log file (use zip to compress it, if too big). Pasting your printer.cfg is not needed
Be sure to check our “Knowledge Base” Category first. Most relevant items, e.g. error messages, are covered there

Describe your issue:

Where should I found the file I specified with [Save_variables] filename: ~/variables.cfg ? I do not found it … after SAVE_VARIABLE VARIABLE= VALUE=

Log follows …

2

With so many pieces of information the solution to your problem is imminent…

2 Likes
3

In der Kürze liegt die Würze !